ISO1176T
Isolated ProfiBus Transceiver
with integrated transformer driver
Description
The ISO1176T is an isolated differential line transceiver with integrated oscillator outputs that provide the primary voltage for an isolation transformer. The device is ideal for long transmission lines because the ground loop is broken to allow the device to operate with a much larger common-mode voltage range. The symmetrical isolation barrier of each device is tested to provide 2500Vrms of isolation between the line transceiver and the logic-level interface.
The galvanically isolated differential bus transceiver is an integrated circuit designed for bi-directional data communication on multipoint bus-transmission lines. The transceiver combines a galvanically isolated differential line driver and differential input line receiver.
View full Description in Datasheet
Features
- 4000Vpeak Isolation, 560Vpeak VIORM
- Meets or Exceeds the Requirements of EN 50170 and TIA/EIA RS-485
- Signaling Rates up to 40 Mbps
- Differential Output exceeds 2.1V (54
Load)
- Low Bus Capacitance 10pF (MAX)
- 50kV/µs Typical Transient Immunity
- UL 1577, IEC 60747-5-2 (VDE 0884, Rev. 2) Approvals Pending
- Fail-safe Receiver for Bus Open, Short, or Idle
- APPLICATIONS
- Profibus
- Factory Automation
- Networked Sensors
- Motor/motion Control
- HVAC and Building Automation Networks
- Networked Security Stations
Profibus is a trademark of Texas Instruments
See Also
- ISO3086 – Isolated 5V RS485 transceiver
- ISO1176 – Isolated Profibus RS-485 transceiver
- ISO35 – Isolated 3.3V RS-485 transceiver
———————————————————————————————-